Easy Wall Print Application
1.
UNPACK – Remove the Wall Print from shipping container and let it sit unrolled for 45 minutes at room temperature. When you receive your Yoga Studio Decor print, don’t be concerned with the dullness of color. This is due to the protective top coating “Magic Mask” that will be removed.
*Freshly painted walls need to wait 30 days prior putting up your wall print.
2.
CLEAN – The surface area you choose must be smooth and clean (no textured walls) Clean the area selected using water only DO NOT USE SOAP OR ANY HOUSEHOLD CLEANING PRODUCT. Dry the surface thoroughly with a clean cloth and let dry for 1hr.
3.
PEEL – The following steps are best performed by two people.
Simply peel the Wall Print, with the “Magic Mask” application tape, from the white paper backing. Each of the two people should hold one of the top corners
4.
POSITION – Place the Print to the wall and press ONLY the outer “Magic Mask” tape to the wall. DO NOT PRESS ANY AREA OF THE actual Print TO THE WALL AT THIS TIME.
Use this process to align the print to the position you want. Don’t worry about air-bubbles at this time. If the Wall Print sticks to itself, DO NOT PANIC, gently pull the two areas apart and re-apply.
5.
STICK – One person will need to hold in place while the second person will begin at one side to apply pressure, using your hand to rub and smooth over the entire print area with the “Magic Mask” still on.
If air-bubbles appear, push them toward outside edges of the Wall Print. If your walls are extremely smooth you can use a credit card like a squegee and slowly push the bubbles out to the edges.
6.
REMOVE MAGIC MASK – Start on a corner and carefully separate the “Magic Mask” and Wall Print from one another. The first few inches will pull the print off the wall, don’t worry after you have about 6″ peeled back simply press the print back against the wall. Now fold the Magic Mask and place your hand on the tacky portion of the “Magic Mask” that is folded back and pull the other person holds the exposed area of the Wall Print. Continue slowly until the “Magic Mask” is completely removed.
7.
STORE – The “Magic Mask” tape is reusable and can be pulled back into it’s original shape. After restoring the “Magic Mask” to it’s original state place the tacky side of the “Magic Mask” to the glossy side of the white paper backing, roll and store in the shipping tube for future use—in the event you decide to remove and store your Wall Print.
Removal
1.
Unroll the paper backing and remove the “Magic Mask” application tape.
2.
The following steps are best performed by two people. Place “Magic Mask” application tape onto Wall Print. Be sure that tape covers entire Wall Print. Use your hand and apply pressure by rubbing “Magic Mask” onto your Wall Print. Utilizing the squeegee, rub entire area again to remove any air-bubbles. If air-bubbles appear, push them toward outside edges of Wall Print.
3.
If your Wall Print is taller than wider, perform this process from top to bottom. If wider than taller, perform process from right to left. Begin peeling back the “Magic Mask” application tape from the wall. When you get to the edge of the Wall Print carefully separate the Wall Print from the wall. Once you have approximately 3″-4″ of the “Magic Mask” and vinyl separated from the wall simply fold this 3″-4″ to the bottom(taller) or left(wider). Place your hand on the tacky portion of the Wall Print that is folded back and pull toward bottom(taller) or right(wider). Continue this process slowly until the “Magic Mask” is completely removed. If the Wall Print separates from the “Magic Mask” at any point—STOP and press Wall Print back onto “Magic Mask”.
4.
Roll and store in shipping tube until the next application process.
